FLANDERS Style Cast Riser Unpainted 37mm

FLANDERS Style Cast Riser Unpainted 37mm

This is an original steel riser designed to match the Glide Riser and Springer top tees, sampling the characteristic rounded shape of FLANDERS.

The height is low at 37mm.

*The height is from the seat of the lower base to the flat part of the top surface.

If measured at the center of the actual handle, it will be a few millimeters higher.

This is a riser set for materials that are cast iron in Japan and have not been treated.

(*It is not chrome-treated, so it will rust if left as is)

You can paint it black, or let it rust and turn it into black rust,
and use it as a custom base for length adjustments, welding, etc.

*The top tightening bolt is not included.
(Please use 5/16-24x1" top bolt size.)

*The tool-insertable surface of the riser is secured so that the tightening tool can be firmly gripped, allowing you to apply the correct torque when tightening.

The seat is designed to be almost the same diameter as the solid mount often used with Glide Risers, so the solid mount disappears when installed and fits in more smartly.

(Similar to Pauco risers.)

The seat diameter is approximately 36.9mm, so it can be used in combination with Springer's earless top tee. is also possible.

(Risers with a smaller seat diameter from other companies cannot be used in combination because the riser will get stuck in the hole in the top tee)

The compatible riser bolt is 1/2-20 fine thread.
Vehicles that already use fine thread bolts can be used as is.

*If you are using 1/2-13 coarse thread bolts,
please purchase 1/2-20 fine thread riser bolts separately.

*Please note that when combined with 39mm triples made after 2004,
the seat diameter is larger than the raised design of the triple,
and they will protrude.